fbpx

How to use endstop switch insead of z probe?

Forums The Beast V1, V2 and Elevator 3D Printer Support How to use endstop switch insead of z probe?

  • This topic is empty.
Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #1178

    My board and/or z probe is malfunctioning and I would like to see whether using an endstop switch will work in its place, as I already have a few lying around. Do I need to alter some firmware setting before I connect a z endstop switch to the board?

    #1423
    dandan
    Participant

    Just connect the endstop power gnd and signal wires (or signal and ground) to the endstop position you wish to test. Shouldn’t need any firmware changes.

    #1424
    dandan
    Participant

    Edit: Moved to The Beast 3D Printer Support

Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.
Facebook Instagram YouTube