fbpx

1.3 glass bed wiggle?

Forums The Beast V1, V2 and Elevator 3D Printer Support 1.3 glass bed wiggle?

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #1198
    tennotenno
    Member

    Hey team.

    Im getting some wobble on each layer thats inconsistant. I think it has to do with the fact that my glass printbed just sits on the acryllic holders and has about 7mm of wiggle room on the x and y when properly leveled.

    Any suggestions on how to minimize this?

    #2156
    cultivate3dDan
    Keymaster

    Sure. If you can observe wobble in the lead screws, try straightening them as much as you can by eye. Also, make sure the grub screw at the bottom isn’t tightening inside the thread and causing the lead screw to skew. Just rotate 1/4 turn and retighten.

    A little double sided tape can’t hurt under the bed corners.

    Also, not sure what version printer you have, but if you have a bearing in the top of the z idler, remove it and let the top of the lead screw remain in retained.

    Dan

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.
Facebook Instagram YouTube