fbpx

Reply To: Frustation…issues…

Forums The Beast V1, V2 and Elevator 3D Printer Support Frustation…issues… Reply To: Frustation…issues…

#2186
phongshaderphongshader
Participant

If you look at the 2nd pic I posted you’ll see how the printer is skipping steps on the x axis on the 1st layer, nothing to catch on at that point… and this only started happening after the failure of the 1st print I posted. The drivers have been rock solid since I installed them, I’ve only had this issue since I switched to the BTT GTR board. With the Rumba32 board I was printing 76 hr prints with no driver issues that’s why it’s a little frustrating to have this problem pop up now…if it’s not one thing it’s another ¯\_(ツ)_/¯

Facebook Instagram YouTube