fbpx

Reply To: Frustation…issues…

Forums The Beast V1, V2 and Elevator 3D Printer Support Frustation…issues… Reply To: Frustation…issues…

#2073
phongshaderphongshader
Participant

I started a print on 11/11 and it actually finished! You were right on the part fan, at full speed the heater was struggling to maintain 230. I lowered the temp to 225 and reduced the fan speed to 75% and got a successful print. I do have another question about the filament sensors. They don’t seem to work. If both sensors have filament and one triggers nothing happens, the printer happily keeps printing. If I have one sensor triggered and one not at the start of a print the printer will not home correctly and fails. the only way I’ve gotten them to work is to have both filament sensors untriggered at the start and then have them both triggered when the filament runs out…not very useful. Hopefully I have something configured wrong. I have the sensors wired up as instructed in the Beast V2 manual and I’ll attach my config files.

P.S. looks like I can’t upload the config files :-/

  • This reply was modified 2 weeks, 4 days ago by phongshaderphongshader.
  • This reply was modified 2 weeks, 4 days ago by phongshaderphongshader.
  • This reply was modified 2 weeks, 4 days ago by phongshaderphongshader.
Facebook Instagram YouTube