fbpx

Reply To: MultiMaterial 2/1 Printer Settings

Forums The Beast V1, V2 and Elevator 3D Printer Support MultiMaterial 2/1 Printer Settings Reply To: MultiMaterial 2/1 Printer Settings

#1977
phongshader
Participant

I did some testing in Cura and there was a SLIGHT improvement but the seem is still prominent.
This is probably more of an issue with 1m bowden tubes than slicers. Is there any advantage to using Capricorn tubing or is it all hype? I’ve read many posts supporting both sides, hype/real. I need to replace my tubing and I’m tempted to go with Capricorn but if there is no real advantage why spend 10x. Can you recommend a good brand?

Facebook Instagram YouTube