Reply To: linear advance

[phongshader]

Send: M503

Recv: echo: G21 ; Units in mm (mm)

Recv: echo: M149 C ; Units in Celsius

Recv:

Recv: echo:; Filament settings: Disabled

Recv: echo: M200 D1.75

Recv: echo: M200 T1 D1.75

Recv: echo: M200 D0

Recv: echo:; Steps per unit:

Recv: echo: M92 X80.13 Y80.12 Z3195.42 E415.00

Recv: echo:; Maximum feedrates (units/s):

Recv: echo: M203 X200.00 Y200.00 Z10.00 E50.00

Recv: echo:; Maximum Acceleration (units/s2):

Recv: echo: M201 X1000.00 Y1000.00 Z100.00 E500.00

Recv: echo:; Acceleration (units/s2): P R T

Recv: echo: M204 P1000.00 R500.00 T1000.00

Recv: echo:; Advanced: B S T J

Recv: echo: M205 B20000.00 S0.00 T0.00 J0.01 <<==is this jerk settings here?

Recv: echo:; Home offset:

Recv: echo: M206 X0.00 Y0.00 Z0.00

Recv: echo:; Unified Bed Leveling:

Recv: echo: M420 S1 Z10.00

Recv:

Recv: Unified Bed Leveling System v1.01 active

Recv:

Recv: echo:; Active Mesh Slot: 1

Recv: echo:; EEPROM can hold 7 meshes.

Recv:

Recv: echo:; Material heatup parameters:

Recv: echo: M145 S0 H190 B60 F0

Recv: echo: M145 S1 H240 B110 F0

Recv: echo:; PID settings:

Recv: echo: M301 P18.03 I0.97 D83.46

Recv: echo: M304 P148.98 I29.30 D504.98

Recv: echo:; Z-Probe Offset (mm):

Recv: echo: M851 X-25.40 Y-6.50 Z-0.20

Recv: echo:; Linear Advance:

Recv: echo: M900 T0 K1.40

Recv: M900 T1 K1.10

Recv: echo:; Filament load/unload lengths:

Recv: echo: M603 T0 L0.00 U100.00

Recv: echo: M603 T1 L0.00 U100.00

Recv: echo:; Tool-changing:

Recv: echo: Z2.00

Recv: echo:; Filament runout sensor:

Recv: echo: M412 S1

Recv: ok