fbpx

Reply To: linear advance

#1512
phongshaderphongshader
Participant

Quote:

Also did you calibrate your extruder?

Yes, 100mm command, 100mm extruded. I’m not sure of the best way to calculate the extrusion multiplier. I tried printing a 2 layer side wall cube and measured the thickness of the wall and adjusted the multiplier based on that but the prints looked under extruded. Then I printed a rectangle 60x100x.75mm and picked the flattest, smoothest print produced at the multiplier used. Clearly the above prints are over extruded. I reduced the multiplier by 3%, to 101% for this print. This was printed with a K factor of .5-1.4 changing every 10% or 10 layers, 190c.

Quote:

Can you reprint with higher X Y Jerk settings

What command do I use to find out what the current jerk settings are?
[attachment=2]IMG_1302.jpg[/attachment][attachment=1]IMG_1303.jpg[/attachment][attachment=0]IMG_1304.jpg[/attachment]

Facebook Instagram YouTube