fbpx

Reply To: linear advance

#1469
phongshaderphongshader
Participant

I did some editing

Code:

// Mechanical endstop with COM to ground and NC to Signal uses “false” here (most common setup).
#define X_MIN_ENDSTOP_INVERTING true // Set to true to invert the logic of the endstop.
#define Y_MIN_ENDSTOP_INVERTING true // Set to true to invert the logic of the endstop.
#define Z_MIN_ENDSTOP_INVERTING false // Set to true to invert the logic of the endstop.
#define X_MAX_ENDSTOP_INVERTING false // Set to true to invert the logic of the endstop.
#define Y_MAX_ENDSTOP_INVERTING false // Set to true to invert the logic of the endstop.
#define Z_MAX_ENDSTOP_INVERTING true // Set to true to invert the logic of the endstop.
#define Z_MIN_PROBE_ENDSTOP_INVERTING false // Set to true to invert the logic of the probe.


gives this result after M502, M500 commands:

Send: M119

Recv: Reporting endstop status

Recv: x_min: open

Recv: y_min: open

Recv: z_min: TRIGGERED

Recv: z_max: open

Recv: filament: open

Recv: ok

changing the logic from false to true

Code:

#define Z_MIN_ENDSTOP_INVERTING false // Set to true to invert the logic of the endstop.

does not

change the state here Recv: z_min: TRIGGERED, but the good news is homing the z axis appears to function now :D

Facebook Instagram YouTube