fbpx

Reply To: linear advance

#1460
phongshaderphongshader
Participant

It does self test.

Code:

Send: M119
Recv: Reporting endstop status
Recv: x_min: open
Recv: y_min: open
Recv: z_min: TRIGGERED
Recv: z_max: TRIGGERED
Recv: filament: open
Recv: ok


M280 P0 S600 deploys

M280 P0 S1500 retracts

When I home the zaxis now the the pin drops, the table rises but does not stop when the pin is pushed in(the sensor never lights) and continues to drive into the printhead until I cut power.

I played around with the zprobe offset, now it doesn’t crash the print head, the bed stops .4mm below the head, but it still doesn’t zero out and the sensor is blinking in error.

Facebook Instagram YouTube