fbpx

Reply To: Layer Shifts / Multi Material 50% Under Extrusion

Forums The Beast V1, V2 and Elevator 3D Printer Support Layer Shifts / Multi Material 50% Under Extrusion Reply To: Layer Shifts / Multi Material 50% Under Extrusion

#1405
mr.smr.s
Member

No, the .47 was for a previous print done with the 2 in 1 firmware. I’m not using that firmware anymore, for the moment.

The last pics I sent you (with the sharpie) were done with multiplier = 1 and single hot end firmware.

Thanks for the tips about the first layer.

Facebook Instagram YouTube