fbpx

Reply To: Layer Shifts / Multi Material 50% Under Extrusion

Forums The Beast V1, V2 and Elevator 3D Printer Support Layer Shifts / Multi Material 50% Under Extrusion Reply To: Layer Shifts / Multi Material 50% Under Extrusion

#1387
dandan
Participant

Do you have none of the ones that came with the printer? They should work for sure.

https://www.amazon.com/HiLetgo-DRV8825-Stepper-RAMPS1-4-StepStick/dp/B01NCE3ZW1/ref=sr_1_5?keywords=DRV8825&qid=1578891834&sr=8-5

Please save and use this gcode to test :

;start of file

; Add Extruder 0 no mixing

M163 S0 P1

M163 S1 P0

M164 S0

; Add Extruder 1 no mixing

M163 S0 P0

M163 S1 P1

M164 S1

M104 S180 T0 ;Preheats Hotend

M109 S180 T0 ; waits for temperature to reach 180

G1 E100 ;Extrudes 100mm

;end of file

I really doubt this is a faulty board. One last test Can you try downloading the single hotend firmware then do the extrusion test. This should eliminate any bugs in the firmware with manual extrusion on a mixing system.

Ill email you when I get in at 8:30am Australian Eastern Standard Time (AEST) – can we setup a teamviewer and facetime (so I can see whats going on)?

Facebook Instagram YouTube