fbpx

Reply To: Layer Shifts / Multi Material 50% Under Extrusion

Forums The Beast V1, V2 and Elevator 3D Printer Support Layer Shifts / Multi Material 50% Under Extrusion Reply To: Layer Shifts / Multi Material 50% Under Extrusion

#1386
mr.smr.s
Member

I flashed the firmware, run M502 and M500 commands, preheated hotend and run G1 E100 command.

50mm came out.

I’m leaning towards a faulty board at this point, but in order to rule everything out I’d like to try the correct drivers in there first.

Can you link to a replacement that you know works for sure?

Facebook Instagram YouTube