fbpx

Reply To: Layer Shifts / Multi Material 50% Under Extrusion

Forums The Beast V1, V2 and Elevator 3D Printer Support Layer Shifts / Multi Material 50% Under Extrusion Reply To: Layer Shifts / Multi Material 50% Under Extrusion

#1385
dandan
Participant

The configuration.h is part of the firmware. Am i correct in assuming you havent tried flashing the firmware?

Perhaps worth a try if not. Download from here : https://cultivate3d.com/firmware

You can follow the process in this video https://youtu.be/QtLlF5emYCU just dont worry about changing any values in the configuration.h file a fresh copy of the firmware will have those changes.

Once the fresh copy of firmware is loaded, Run M502 then M500 to clear eeprom

Facebook Instagram YouTube