fbpx

Reply To: Layer Shifts / Multi Material 50% Under Extrusion

Forums The Beast V1, V2 and Elevator 3D Printer Support Layer Shifts / Multi Material 50% Under Extrusion Reply To: Layer Shifts / Multi Material 50% Under Extrusion

#1369
mr.smr.s
Member

The flow multiplier has always been at 100%.

Not sure where I can see it on Repetier. Is it the bar called feedrate in the Manual Control tab? That’s at 100 as well.

I can’t find those cubes anymore (I printed 2, just to make sure the first wasn’t a mistake). I threw them away. Both of them had a big lump protruding out of the Y face, and the other surfaces were all bumpy and lacking detail as well.

Accelerations are way higher than 200, but the extruder is not skipping steps or making any beeping noises.

I took the value down from 5000 to 200 for the test. Exactly 100mm of filament came out.

Facebook Instagram YouTube