› Forums › The Beast V1, V2 and Elevator 3D Printer Support › Layer Shifts / Multi Material 50% Under Extrusion › Reply To: Layer Shifts / Multi Material 50% Under Extrusion
January 10, 2020 at 7:37 pm
#1368

Participant
Ensure your LCD flow multiplier is set to 100%. This should reset if you power cycle your printer.
Next open repetier host, connect and ensure the flow multiplier is set to 100% too.
Leave printer connected to rep host. Pre Heat hotend
Remove Bowden tube from hotend and trim filament flush with tube
Now from the gcode section run G1 E100 and measure the filament that comes out.