fbpx

Reply To: Layer Shifts / Multi Material 50% Under Extrusion

Forums The Beast V1, V2 and Elevator 3D Printer Support Layer Shifts / Multi Material 50% Under Extrusion Reply To: Layer Shifts / Multi Material 50% Under Extrusion

#1364
dandan
Participant

It’s not possible to have over extrusion during a print but not when manually extruding, unless a sliver setting such as 2.0 extrusion multiplier is screwing with things. The manual command for extruding 100mm is exactly the same as that used in gcode. I’m going to have a think about this and get back a little later on. Perhaps we need to do a teamviewer and FaceTime?

Facebook Instagram YouTube