fbpx

Reply To: Layer Shifts / Multi Material 50% Under Extrusion

Forums The Beast V1, V2 and Elevator 3D Printer Support Layer Shifts / Multi Material 50% Under Extrusion Reply To: Layer Shifts / Multi Material 50% Under Extrusion

#1359
mr.smr.s
Member

I do have an AC motor speed controller which I use to set the bed at around 65-70 deg. Seems to work well for this material and the Nano Polymer adhesive. If I turn it off before the print is done I incur the risk of the part detaching from the bed.

So I printed a test cube with heated bed.The result was severely over-extruded.

I took the multiplier down to 0.5 and it’s much better. Maybe still a little over-extruded on the edges as I was coming from 0.95 before doubling the extruder steps per mm. I might try to go down to 0.48, or command the fan at 100% from the second layer on, or a combination of the two.

Facebook Instagram YouTube