fbpx

Reply To: Layer Shifts / Multi Material 50% Under Extrusion

Forums The Beast V1, V2 and Elevator 3D Printer Support Layer Shifts / Multi Material 50% Under Extrusion Reply To: Layer Shifts / Multi Material 50% Under Extrusion

#1358
dandan
Participant

Ok, so your test cube pictures were almost useless. I couldnt see what was going on with the surfaces due to the transperant filament, bad angle and fuzzy photography.

Could you please turn OFF your heated bed and print another, this time I need to see a nice clear side on angle. If you need to use the heated bed. Do you have an AC motor speed controller yet? You should be able to make standard PLA stick to a cold bed with hair spray, kapton tape, blue painters tape etc. If you must and you dont have an AC motor speed controller for your heated bed, turn off the bed after the first few layers.

Facebook Instagram YouTube