fbpx

Reply To: Layer Shifts / Multi Material 50% Under Extrusion

Forums The Beast V1, V2 and Elevator 3D Printer Support Layer Shifts / Multi Material 50% Under Extrusion Reply To: Layer Shifts / Multi Material 50% Under Extrusion

#1352
dandan
Participant

You will continue to have a hard time getting that first layer to stick until your extruder is doing what the software thinks it should be doing. Adjust your steps per mm for EXT 0 and 1 to 835 and run that extrusion calibration test again. Please report the exact amount of filament extruded.

Facebook Instagram YouTube