fbpx

Reply To: Layer Shifts / Multi Material 50% Under Extrusion

Forums The Beast V1, V2 and Elevator 3D Printer Support Layer Shifts / Multi Material 50% Under Extrusion Reply To: Layer Shifts / Multi Material 50% Under Extrusion

#1336
mr.smr.s
Member

Here is the picture. I wrote cms but it’s actually a couple mms.

I thought I read somewhere in one of your posts that the DRV8825 drivers you use are not going to cause skipped steps, just high temperature.

I’ll go through the VREF procedure again.

Facebook Instagram YouTube