fbpx

Reply To: How to update Firmware AND Bed Homing into nozzle – Probe Error – Not homing correctly, Auto level failing

Forums The Beast V1, V2 and Elevator 3D Printer Support How to update Firmware AND Bed Homing into nozzle – Probe Error – Not homing correctly, Auto level failing Reply To: How to update Firmware AND Bed Homing into nozzle – Probe Error – Not homing correctly, Auto level failing

#1332
dandan
Participant

Open up repetier host , go to the manual control > gcode tab and enter M340 P0 S600 . Does the probe drop? Now type M340 P0 S1500 Does the probe raise? If it raises or lowers, does this occur the moment you press enter? Is there a delay?

I have a feeling those codes wont work from what youve described meaning you need to check the wires running between the probe and the EXP3 connector on your main board (the 3 wires). A Multimeter on beeper mode will assist greatly here. Phongshader has reported an issue with some of the header pins we supplied to extend wires – said that his were too tin and didnt make good connection. Perhaps you could check and let me know. If need be ill send some fatter ones.

Facebook Instagram YouTube