fbpx

Reply To: Calibration/Tuning instructions

Forums The Beast V1, V2 and Elevator 3D Printer Support Calibration/Tuning instructions Reply To: Calibration/Tuning instructions

#1302
phongshaderphongshader
Participant

I thought I replied to this this morning…I haven’t had a chance to look at the printer to check out the hot end but I’ve had it off a few times clearing clogs so I’m fairly sure that it’s not loose. The belts on the other hand may be loose. How would I check the squareness of the x axis other than eyeballing it?

Facebook Instagram YouTube