fbpx

Reply To: Calibration/Tuning instructions

Forums The Beast V1, V2 and Elevator 3D Printer Support Calibration/Tuning instructions Reply To: Calibration/Tuning instructions

#1294
phongshaderphongshader
Participant

The print quality is getting better, these are printed with a raft and a multiplier of .95. I’ve run into an anomaly…I don’t know if this is a slicer issue or a printer issue. If you look at the attached photos you’ll see that the printer is not laying down circles but circles with a small flat sides on the y axis. These flat sides are not present in the slicer simulation.

Facebook Instagram YouTube