fbpx

Reply To: Calibration/Tuning instructions

Forums The Beast V1, V2 and Elevator 3D Printer Support Calibration/Tuning instructions Reply To: Calibration/Tuning instructions

#1293
dandan
Participant

Still looks a bit over extruded. Please reduce the extrusion Multiplier by 5%. In terms of your supports, small fine supports are a recipient for disaster. Try increasing the support size to give it more footing and print with a brim 0cm from the parts to give the supports a nice pad to help with adhesion to the bed. A few support base layers also wouldn’t hurt. I’m sure there are a few videos on customising supports in simplify3d that would hurt to watch.

Facebook Instagram YouTube