fbpx

Reply To: Calibration/Tuning instructions

Forums The Beast V1, V2 and Elevator 3D Printer Support Calibration/Tuning instructions Reply To: Calibration/Tuning instructions

#1292
phongshaderphongshader
Participant

Something funny happened when I reverted to the “correct” steps/mm for the extruder…it was extruding the correct amount, not half. I don’t know what happened but I messed around with those settings for a week and could never get them right and then last night it worked. ¯_(ツ)_/¯

The print has gotten much better but could still improve.
[attachment=2]IMG_1078.jpg[/attachment][attachment=1]IMG_1079.jpg[/attachment]
The supports under the center of the wheel printed but then failed as soon as the wheel started to print on the supports.
[attachment=0]IMG_1081.jpg[/attachment]

Facebook Instagram YouTube