fbpx

Reply To: Calibration/Tuning instructions

Forums The Beast V1, V2 and Elevator 3D Printer Support Calibration/Tuning instructions Reply To: Calibration/Tuning instructions

#1289
dandan
Participant

Hi Phongshader I’m sure you’re following this.

https://cultivate3d.com/forums/viewtopic.php?f=3&t=51&e=1

Those pictures look like they’re way way over extruded causing layer shift from bed moving or part moving usually because the nozzle is catching. This layer shift is different from typical skipped steps as the shift is gradual, rather than big obvious chunky shifts. I have a feeling the key here may be to set the steps per mm back to 417.5 with 16x microstepping 1.0 multiplier and ignore the fact that manual extrusion does strange things with MM firmware.

By the way, while that was printing, could you hear the nozzle dragging over the print during travel moves?

Facebook Instagram YouTube