fbpx

Reply To: Calibration/Tuning instructions

Forums The Beast V1, V2 and Elevator 3D Printer Support Calibration/Tuning instructions Reply To: Calibration/Tuning instructions

#1286
phongshaderphongshader
Participant

Any suggestions on how to proceed? I’m getting over-extrusion with my current settings 820.63 and yet the amount of filament extruded from the titan extruder matches the input. I’ve had to dial back the extrusion multiplier to .75 in s3d to get to a finished print but it’s still too much. Again if I set to

417.5 steps/mm the extruded filament is cut in half, 100 input 51.36 output.
[attachment=0]IMG_1065.jpg[/attachment]

Facebook Instagram YouTube