fbpx

Reply To: Calibration/Tuning instructions

Forums The Beast V1, V2 and Elevator 3D Printer Support Calibration/Tuning instructions Reply To: Calibration/Tuning instructions

#1282
dandan
Participant

Hmmm, if you’re getting the wrong amount of filament out of your extruder, 100% the problem is you’ve not set the microstepping jumpers under the stepper drivers. Please check around page 75 of the CURRENT manual as these settings have changed during the past year.

You should not need to diverge from the set values much at all. Around 417 is the correct value.

You are correct. We do use repetier firmware. We also use generic components such as the hotend and extruders.

I’ll consider adding this detail to the manual despite the fact this has been documented with excellent relevance in countless other places.

Facebook Instagram YouTube